Learn all About the new internet Money bitcoin, The new Currency that will change the World. click here
War Commander Base Layout
Building a strong base is crucial for succeeding in War Commander game .In this page I’ll try to give you some about War Commander base layout.
Sandbags are an example of weak wall. Bullets will not path it.
Bullet-carrying units/vehicles will shoot through them.
Sandbags are used by low level players.
Sandbags has 200 health.
Concrete blocks has 50% more health than Sandbags. Concrete blocks costs 50,000 metal and 20,000 oil to be upgraded.
Concrete is best for players with level 2 CC.
After upgrading the CC to level 3,start already upgrading your walls to Barricades.
Barricade blocks costs 200,000 metal and 100,000 oil to be upgraded.
Barricade blocks need to be destroyed first before units and vehicles can shoot.
Barricade blocks has 150% more health than Concrete Blocks.
building placement war commander Base Layout:
cc/storage: covered on all sides by turrets in the safest place possible gun towers: these are the most important defensive weapon because they are the best at destroying infantry and air units, keep these upgraded and covered by units and mortar towers.
mortar towers: these are beasts vs. vehicles, put them near gun turrets so that they can hit enemy vehicles. power plant: important to have each well upgraded enough for one to power the entire base, put them at opposite sides but still well covered
rgs: put them around the center of the base, but donít waste resources defending them, they are only there to slow the enemy down
Walls: put them around the towers, and spread out like so that the enemy cant fly next to your defenses.
Destroy the enemy step by step war commander Base Layout
This attack strategy will allow you to destroy other bases and raid massive amounts of resources more easily.
Both from players and from computer controlled bases that are a higher level and contain more resources,
as well as heavier defenses.
This attack strategy will allow you to more easily destroy other bases and raid massive amounts of resources,
both from players and from computer controlled bases that are a higher level and contain more resources,
as well as heavier defenses.
To make this first phase quicker, keep your units back from the main areas of the base and try to lure their units out to attack your units. Then pick them off and end the attack.
This is phase one of the attack. Phase two begins after you finish off their units.
Now, you have the gun turrets to deal with, but instead of directly targeting their gun turrets,
target their power plants. Riflemen are recommended for this part too due to their disposable nature,
especially if they run a lot of turrets. Take out their power plants,
and their turrets will be deactivated due to a lack of power.
Now that their troops are gone and their guns are useless, phase two ends and phase three begins. This is the easy phase, because with no defenses left at the invaded base,
you’re free to raid and destroy every other building on the base and load up on resources.
That’s an easy way to take out other bases and avoid prematurely throwing the other player into damage protection.
Use this as well to avoid getting all of your troops killed by the opposition’s defenses!
And don’t forget War commander base layout is a key factor in War commander game. so built your war commander base layout carefully !
Check out more War commander tips about the Battle Ground